NXP LPC15xx系列MCU马达控制方案

 Serial Wire Debug (SWD) with four breakpoints and two watchpoints.
 Single-cycle multiplier supported.
 Memory Protection Unit (MPU) included.
 Memory:
 Up to 256 kB on-chip flash programming memory with 256 Byte page write anderase.
 Up to 36 kB SRAM.
 4 kB EEPROM.
 ROM API support:
 Boot loader with boot options from flash or external source via USART, C_CAN, orUSB
 USB drivers
 ADC drivers
 SPI drivers
 USART drivers
 I2C drivers
 Power profiles and power mode configuration with low-power mode configurationoption
 DMA drivers
 C_CAN drivers
 Flash In-Application Programming (IAP) and In-System Programming (ISP).
 Digital peripherals:
 Simple DMA engine with 18 channels and 20 programmable input triggers.
 High-speed GPIO interface with up to 76 General-Purpose I/O (GPIO) pins with configurable pull-up/pull-down resistors, open-drain mode, input inverter, andprogrammable digital glitch filter.
 GPIO interrupt generation capability with boolean pattern-matching feature on eight external inputs.
 Two GPIO grouped port interrupts.
 Switch matrix for flexible configuration of each I/O pin function.
 CRC engine.
 Quadrature Encoder Interface (QEI).
 Configurable PWM/timer/motor control subsystem:
 Up to four 32-bit counter/timers or up to eight 16-bit counter/timers or combinations
of 16-bit and 32-bit timers.
 Up to 28 match outputs and 22 configurable capture inputs with input multiplexer.
 Up to 28 PWM outputs total.
 Dither engine for improved average resolution of pulse edges.
 Four State Configurable Timers (SCTimers) for highly flexible, event-driven timing
and PWM applications.
 SCT Input Pre-processor Unit (SCTIPU) for processing timer inputs and immediate handling of abort situations.
 Integrated with ADC threshold compare interrupts, temperature sensor, and analog comparator outputs for motor control feedback using analog signals.

低压高频CMOS电流乘法器原理图低压高频CMOS电流乘法器原理图通过调节跨导参数k和参数a，来调节乘法器的增益。参数k和MOS管的尺寸直接相关。减小跨导参数k或MOS管的尺寸，带来了较高的增益和较低的功耗，同时由于与MOS管相关的较

正弦波电压变大，变压器畸变电流急剧增加，请大神分


电路图如上，正弦波频率9KHz，正弦波幅值增加的时候，流过线圈1-3的电流急剧增加，请各位大神分析一下原因。


上传几张波形图：










CH1:变压器1脚和

电弧产生原理图电弧产生原理图也是一个简易高压发生器电路，使用一块固定频率脉宽调制电路TL494 产生方波信号控制MOS 管Q1，Q1 上的交变电流在通过串联的黑白电视机高压包T 的时候升压到2k~10kV，升压后经

大电流电感

 2/7   首页 上一页 1 2 3 4 5 6 下一页 尾页